R2511-HP MSR Router Series Voice Command Reference(V5)

144
undo timer ring { ringback | ringbusy }
Default
The duration of playing the ringback tone is 60,000 milliseconds and that of playing the busy tone is
30,000 milliseconds.
Views
R2 CAS view
Default command level
2: System level
Parameters
ringback time: Sets the duration in milliseconds of playing ringback tone, in the range of 1000 to
90000.
ringbusy time: Sets the duration in milliseconds of playing busy tone, in the range of 1000 to 90000.
Examples
# Set the duration of playing the ringback tone to 10,000 milliseconds when R2 signaling is adopted.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] timer ring ringback 10000
Related commands
sendring
timeslot-set
Use timeslot-set to create a TS set and specify a signaling mode for it on the E1/T1 interface.
Use undo timeslot-set to remove the TS set.
Syntax
timeslot-set ts-set-number timeslot-list timeslots-list signal { e&m-delay | e&m-immediate | e&m-wink |
fxo-ground | fxo-loop | fxs-ground | fxs-loop | r2 }
undo timeslot-set ts-set-number
Default
No TS set is configured.
Views
E1 interface view, T1 interface view
Default command level
2: System level
Parameters
ts-set-number: TS set number in the range of 0 to 30 for an E1 interface and 0 to 23 for a T1 interface.