R2511-HP MSR Router Series Voice Command Reference(V5)

171
send-number
Use send-number to configure the number sending mode.
Use undo send-number to restore the default number sending mode.
Syntax
send-number { digit-number | all | truncate }
undo send-number
Default
The truncate mode is used.
Views
POTS entity view
Default command level
2: System level
Parameters
digit-number: Number of digits (that are extracted from the end of a number) to be sent, in the range of
0 to 31. It is not greater than the total number of digits of the called number.
all: Sends all digits of a called number.
truncate: Sends a truncated called number.
Usage guidelines
This command applies to only POTS voice entities. This command is used to control how to send called
numbers to PSTN. You can specify to send some digits (defined by the digit-number argument from right
to left) or all digits of called numbers. You can also specify to send truncated called numbers, namely, the
ending digits of called numbers that match the dot (.).
Here the dot represents the digits that match the variable part in a regular expression. For more
information, see Voice Configuration Guide.
Examples
# Configure voice entity 10 to send the last six digits of a called number.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 pots
[Sysname-voice-dial-entity10] send-number 6
Related commands
• dot-match
• match-template
subscriber-group
Use subscriber-group to create a subscriber group and enter subscriber group view, or directly enter the
subscriber group view if the subscriber group already exists.
Use undo subscriber-group to delete a subscriber group or all subscriber groups.