R2511-HP MSR Router Series Voice Command Reference(V5)

292
Fax over IP configuration commands
default entity fax
Use default entity fax to set fax parameters to the default values globally.
Use undo default entity fax to restore the fax parameters of the system to the defaults.
Syntax
default entity fax baudrate { 2400 | 4800 | 9600 | 14400 | disable | voice }
default entity fax ecm
default entity fax level level
default entity fax local-train threshold threshold
default entity fax nsf-on
default entity fax protocol { standard-t38 | t38 } [ hb-redundancy number | lb-redundancy number ]
default entity fax protocol pcm { g711alaw | g711ulaw }
default entity fax train-mode { local | ppp }
default entity fax cng-switch enable
default entity modem protocol pcm { standard | nte-compatible } { g711alaw | g711ulaw }
undo default entity fax { baudrate | ecm | cng-switch | level | local-train threshold | nsf-on | protocol
| train-mode }
undo default entity fax cng-switch enable
undo default entity modem protocol pcm
Views
Voice dial program view
Default command level
2: System level
Parameters
baudrate: Specifies the maximum fax transmission rate. The inherent default is voice.
• 2400: Sets the maximum transmission rate to 2400 bps.
• 4800: Negotiates the baud rate first in accordance with the V.27 fax protocol. The maximum
transmission rate is 4800 bps.
• 9600: Negotiates the baud rate first in accordance with the V.29 fax protocol. The maximum
transmission rate to 9600 bps.
• 14400: Negotiates the baud rate first in accordance with the V.17 fax protocol. The maximum
transmission rate to 14,400 bps.
• disable: Disables fax forwarding.( If the call control protocol is SIP, this keyword disables
forwarding of private T.38 and standard T.38 faxes only.)
• voice: Sets the fax rate to the allowed maximum voice speed for different codec protocols.