R2511-HP MSR Router Series Voice Command Reference(V5)

300
Default command level
2: System level
Parameters
threshold: Local training threshold in percentage, in the range of 0 to 100.
Usage guidelines
Point-to-point training means the gateways do not participate in the rate training between two fax
terminals. In this mode, rate training is performed between two fax terminals and is transparent to the
gateways.
For the point-to-point training, the gateway does not participate in rate training and the threshold is
invalid.
When the local training mode is adopted, the local training threshold configured with the fax local-train
threshold command is valid. When the PPP training mode is adopted, the gateway does not participate
in the rate training and the local training threshold is invalid.
Examples
# Configure the percentage of the local training threshold to 20.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 pots
[Sysname-voice-dial-entity10] fax local-train threshold 20
fax nsf-on
Use fax nsf-on to configure the signal transmission mode of fax faculty as a nonstandard mode.
Use undo fax nsf-on to restore the default transmission mode.
Syntax
fax nsf-on
undo fax nsf-on
Default
The standard signal transmission mode of fax faculty is adopted.
Views
POTS entity view, VoIP entity view, VoFR entity view
Default command level
2: System level
Examples
# Configure a nonstandard faculty for fax signal transmission.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 pots
[Sysname-voice-dial-entity10] fax nsf-on