R2511-HP MSR Router Series Voice Command Reference(V5)

324
VoFR configuration commands
address
Use address to configure a channel to the peer voice gateway.
Use undo address to remove the configuration.
Syntax
address { vofr-dynamic serial interface-number dlci-number | vofr-static serial interface-number
dlci-number cid-number }
undo address { vofr-dynamic | vofr-static }
Default
No channel to the peer voice gateway is configured.
Views
VoFR entity view
Default command level
2: System level
Parameters
vofr-dynamic: Specifies a VoFR entity to adopt the dynamic call mode.
vofr-static: Specifies a VoFR entity to adopt the FRF.11 trunk mode.
serial interface-number: Specifies the destination interface of a VoFR entity.
dlci-number: Destination virtual circuit number of a VoFR entity, in the range of 16 to 1007.
cid-number: Destination FRF.11 sub-channel number of a VoFR entity, in the range of 4 to 255.
Usage guidelines
The FRF.11 sub-channel number to be configured must be available. That is, the FRF.11 sub-channel is not
occupied.
A voice channel is established for the VoFR entity immediately you execute the address vofr-static
command. The voice channel is removed after you execute the undo form of the command or delete the
VoFR entity.
Examples
# Specify DLCI 100 to adopt the dynamic call mode.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 4 vofr
[Sysname-voice-dial-entity4] match-template 12345
[Sysname-voice-dial-entity4] address vofr-dynamic serial1/0 100
Related commands
• call-mode