R2511-HP MSR Router Series Voice Command Reference(V5)

341
card-digit
Use card-digit to configure the number of digits in a card number for some access number in the card
number/password process.
Use undo card-digit to restore the default.
Syntax
card-digit card-digit
undo card-digit
Default
The number of digits in a card number is 12 only when an access number is already configured for the
card number/password process (by using the process-config command).
Views
Access number view
Default command level
2: System level
Parameters
card-digit: Number of digits in a card number, in the range of 1 to 31.
Usage guidelines
This command is used to configure the number of digits in a card number for the card number/password
process. Once the number of digits is fixed, all users who use the access number must enter a fixed-length
card number. Otherwise, the voice gateway reports an error.
The card-digit command is available in access number view only after you use the process-config
command to specify the dialing process as card number/password process.
Examples
# Specify the number of digits in a card number as 10 for the access number 17909.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] gw-access-number 17909
[Sysname-voice-dial-anum17909] process-config cardnumber
[Sysname-voice-dial-anum17909] card-digit 10
Related commands
• gw-access-number
• process-config
cdr
Use cdr to configure a rule for saving CDRs.
Use undo cdr to restore the default saving rule, and the undo cdr all command to restore the values of
buffer, duration, and threshold all to the defaults.