R2511-HP MSR Router Series Voice Command Reference(V5)

352
password-digit
Use password-digit to configure the number of digits in a password for some access number in the card
number/password process.
Use undo password-digit to restore the default number of digits in a password for some access number
in the card number/password process.
Syntax
password-digit password-digit
undo password-digit
Default
The number of digits in a password for some access number in the card number/password process is 6.
Views
Access number view
Default command level
2: System level
Parameters
password-digit: Number of digits in a password, in the range of 1 to 16.
Usage guidelines
This command is unavailable for the caller number process with IVR. Before executing the password-digit
command, you must use the process-config command to specify the two-stage dialing process for the
configured access number as card number/password process. The password-digit command is
available only in access number view.
Examples
# Specify the number of digits in a password as 4 for the access number 17909.
<Sysname>system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] gw-access-number 17909
[Sysname-voice-dial-anum17909] process-config cardnumber
[Sysname-voice-dial-anum17909] password-digit 4
# Restore the default number of digits in a password for the access number 17909.
[Sysname-voice-dial-anum17909] undo password-digit
Related commands
• gw-access-number
• process-config
process-config
Use process-config to specify a dialing process for an access number.
Use undo process-config to restore the default dialing process for an access number.