R2511-HP MSR Router Series Voice Command Reference(V5)

353
Syntax
process-config { callernumber | cardnumber | voice-caller }
undo process-config
Default
The caller number process with IVR is specified for all access numbers.
Views
Access number view
Default command level
2: System level
Parameters
callernumber: Specifies the two stage-dialing process as caller number process. After a user dials an
access number, the voice gateway continues to play dial tones, prompting for a called number. In this
process, the user authentication is implemented by identifying the calling number, and no more
additional parameter configurations are required.
cardnumber: Specifies the two-stage dialing process as card number/password process. After a user
dials an access number, the voice gateway continues to play prompt tones, requiring the user to enter a
card number and password. In this process, the user authentication is implemented by identifying the
prepaid card number and password, and you can configure parameters by using the card-digit,
password-digit, and redialtimes commands.
voice-caller: Specifies the two-stage dialing process as caller number process with IVR. After a user dials
an access number, the voice gateway plays prompt tones, requiring the user to dial a called number. In
this process, the user authentication is implemented by identifying the calling number. If the
authentication succeeds, the voice gateway plays prompt tones, requiring the user to dial a called
number. In addition, you can configure the number of redial attempts by using the redialtimes command,
and the language in which the prompt tones are played by using the selectlanguage command.
Usage guidelines
Each access number has a specific dialing process. Calls originated by users who dial a certain access
number are established in accordance with the same dialing process.
Differences between the caller number process and the caller number process with IVR are as follows:
• In the caller number process, after a user dials an access number, the voice gateway plays only dial
tones (long tones).
• In the caller number process with IVR, after a user dials an access number, the voice gateway plays
prompt tones, requiring the user to dial a called number.
In the card number/password process, with the authentication function disabled, a user can enter any
two numbers as a card number and password respectively to make an IP call as long as they meet the
length requirements.
After a dialing process is specified, parameters not related to the process are set to the default values and
the corresponding commands are unavailable. Parameters related to the card number/password
process include number of digits in a card number and number of digits in a password. The language
selection function is applicable only to the caller number process with IVR, while the number of redial
attempts is applicable to only the card number/password process and the caller number process with
IVR.