R2511-HP MSR Router Series Voice Command Reference(V5)

34
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 pots
Related commands
line
fast-connect
Use fast-connect to enable H.323 fast connection.
Use undo fast-connect to disable H.323 fast connection.
Syntax
fast-connect
undo fast-connect
Default
Fast connection is disabled.
Views
VoIP voice entity view
Default command level
2: System level
Usage guidelines
As there is no ability negotiation for fast connection mode, the ability confirmation of the two parties is
determined by the called gateway. When the router acts as an originating gateway, you can set whether
or not to apply fast connection mode for each originated call. When the router acts as a terminating
gateway, the configuration of the voip called-start command will determine whether fast connection is
used for call initialization.
Fast connection procedure will be used when both the calling and called parties support fast connection.
Provided that neither the calling nor the called gateway supports fast connection mode, the system will
automatically switch to normal connect procedure to resume the call.
It is OK to only configure fast-connect command for VoIP voice entity on the calling gateway. After
successfully enabling fast connection, you can configure the tunnel function.
Examples
# Enable fast connection for VoIP voice entity 10.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 voip
[Sysname-voice-dial-entity10] fast-connect
Related commands
• outband
• tunnel-on
• voip called-start