R2511-HP MSR Router Series Voice Command Reference(V5)

45
Default command level
2: System level
Parameters
value: Specifies the timeout interval in seconds for RTP streams, in the range of 10 to 300.
Examples
# Set the timeout interval for RTP streams to 60 seconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] rtp-detect timeout 60
send-ring
Use send-ring to enable the local end to play ringback tone.
Use undo send-ring to disable the local end from playing ringback tone.
Syntax
send-ring
undo send-ring
Default
The local end does not play ringback tone.
Views
POTS voice entity view, VoIP voice entity view, VoFR entity view
Default command level
2: System level
Usage guidelines
In VoIP view, this command is available only after the fast connection function is enabled or a SIP routing
policy is configured. In POTS view, you can configure this command as long as the line line number
command binds the POTS voice entity to a voice subscriber line rather than an FXS or FXO voice
subscriber line.
Examples
# Enable the local end to play ringback tone.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 voip
[Sysname-voice-dial-entity10] fast-connect
[Sysname-voice-dial-entity10] send-ring
shutdown (voice entity view)
Use shutdown to change the management status of the specified voice entity from UP to DOWN.
Use undo shutdown to restore the default management status of the voice entity.