R2511-HP MSR Router Series Voice Command Reference(V5)

47
During actual configuration, it is only necessary to fulfill this command for the VoIP voice entity at the
calling gateway.
Examples
# Enable the tunnel function for VoIP voice entity 10.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 voip
[Sysname-voice-dial-entity10] fast-connect
[Sysname-voice-dial-entity10] tunnel-on
Related commands
• fast-connect
• outband
• voip called-tunnel enable
• voip called-start
vad-on
Use vad-on to enable VAD.
Use undo vad-on to disable VAD.
Syntax
vad-on [ g711 | g723r53 | g723r63 | g729a | g729r8 ]
undo vad-on [ g711 | g723r53 | g723r63 | g729a | g729r8 ]
Default
VAD is disabled.
Views
POTS voice entity view, VoIP voice entity view, VoFR entity view
Default command level
2: System level
Parameters
g711: Specifies the g711 codec.
g723r53: Specifies the g723r53 codec.
g723r63: Specifies the g723r63 codec.
g729a: Specifies the g729a codec.
g729r8: Specifies the g729r8 codec.
Usage guidelines
If you execute the vad-on or undo vad-on command without specifying a codec, VAD for all codecs is
enabled or disabled.
The G.726 codecs does not support VAD.
The G.729br8 codec always supports VAD.