R2511-HP MSR Router Series Voice Command Reference(V5)

51
Default
The fast connection mode is used for call initialization.
Views
Voice view
Default command level
2: System level
Parameters
fast: The called GW initializes calls in a fast way.
normal: The called GW initializes calls in a non-fast way.
Usage guidelines
As the process of faculty negotiation is omitted in fast connection procedures, the faculties of the two
parties are determined by the GW. If a router acts as a calling GW, you can enable or disable fast
connection for each channel of initiated calls. If it acts as a called GW, it will use or not use the fast
connection mode to initialize calls depending on the parameters of the voip call-start command, in the
case that the calling GW uses the fast connection mode.
Examples
# Configure the called gateway to initialize calls in normal mode.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] voip called-start normal
Related commands
fast-connect
voip timer
Use voip timer to set the time duration for switching from the current VoIP link to another VoIP link or a
PSTN link in case of a VoIP call failure.
Use undo voip timer to restore the default.
Syntax
voip timer voip-to-pots time
undo voip timer voip-to-pots
Default
The duration is 5 seconds.
Views
Voice view
Default command level
2: System level