R2511-HP MSR Router Series Voice Command Reference(V5)

66
Default
The amplitude is 1000 for busy tone and congestion tone, 400 for dial tone and special dial tone, and
600 for ringback tone and waiting tone.
Views
Voice view
Default command level
2: System level
Parameters
all: All types of call progress tones.
busy-tone: Busy tone.
congestion-tone: Congestion tone.
dial-tone: Dial tone.
ringback-tone: Ringback tone.
special-dial-tone: Special dial tone.
waiting-tone: Waiting tone.
amplitude value: Amplitude of a progress tone, in the range of 200 to 1500.
Examples
# Set the amplitude of the busy tone to 1,200.
<sysname> system-view
[sysname] voice-setup
[sysname-voice] cptone tone-type busy-tone amplitude 1200
default
Use default to restore the default settings for a voice subscriber line.
Syntax
default
Views
Voice subscriber line view
Default command level
2: System level
Usage guidelines
The default command might interrupt ongoing network services. Make sure you are fully aware of the
impacts of this command when you perform it on a live network.
This command might fail to restore the default settings for some commands for reasons such as command
dependencies and system restrictions. Use the display this command in interface view to identify these
commands, and then use their undo forms or follow the command reference to individually restore their
default settings. If your restoration attempt still fails, follow the error message instructions to resolve the
problem.