R2511-HP MSR Router Series Voice Command Reference(V5)

77
Field Description
Phy-status
Status of the voice subscriber line:
• ADM—The subscriber line is shut down by using the shutdown command.
• DOWN—The subscriber line is administratively up but physically down
(possibly because no physical link is present or the link has failed).
• UP(S)—The subscriber line is up at the link layer, but its link is an on-demand
link or not present at all. This attribute is typical of BSV interfaces.
• UP—The subscriber line is up.
Call Status
Call status of the voice subscriber line:
• IDLE.
• SENDNUMBER.
• RECEIVENUMBER.
• CALLIN—The subscriber line is in callout state.
• CALLOUT—The subscriber line is in callin state.
• SEIZE.
• SEIZEACK.
• RING.
• RINGBACK.
• BUSYTONE.
• TALKING.
• RELEASING.
• BINDINSTALLING—The FXO subscriber line is being installed.
• BINDFXOOFFHOOK—The FXO subscriber line is bound and in forced off-hook
state.
• BINDFXOONHOOK—The FXO subscriber line is bound and in forced on-hook
state.
• UNKNOWN.
• N/A—There is no call status for the subscriber line.
Private-line
Called number for the PLAR function:
• N/A—The subscriber line does not support the PLAR function.
• Not Set—The subscriber line is not configured with the PLAR function.
Related commands
subscriber-line
dtmf amplitude
Use dtmf amplitude to configure the DTMF amplitude. Once configured, the parameter applies to the
whole device.
Use undo dtmf amplitude to restore the default value.
Syntax
dtmf amplitude value
undo dtmf amplitude
Default
The DTMF amplitude is – 9.0 dBm.