Manualshelf

R2511-HP MSR Router Series Voice Command Reference(V5)

ManualsBrandsHP ManualsNetwork HardwareHP MSR1003-8 AC Router
919293949596979899100
87
Parameters
fxs_subscriber_line: FXS voice subscriber line bound to the FXO voice subscriber line.
ring-immediately: Specifies the immediate ringing mode.
Usage guidelines
After an FXS voice subscriber line is bound to the FXO voice subscriber line, the off-hook/on-hook state
of these two lines will be consistent.
To keep the consistent off-hook/on-hook state between the bound FXS and FXO voice subscriber lines,
consider the configurations of the private-line and caller-permit commands when executing the
hookoff-mode delay bind fxs_subscriber_line command. The FXS voice subscriber line specified by
fxs_subscriber_line must be the one to which the private line number points. In addition, only the bound
FXS voice subscriber line is allowed to originate calls to the FXO voice subscriber line by restricting
incoming calls. For more information about the private-line and caller-permit command, see "Dial plan
configuration commands."
The bound FXS and FXO voice subscriber lines must come from the same device.
Use the ring-immediately keyword to quicken ringing synchronization between the FXO voice subscriber
line and its bound FXS voice subscriber line. However, for the telephone supporting calling identification
display, the calling number will be displayed after the second ringing tone.
Examples
# Specify the delay off-hook mode for the FXO voice subscriber line and bind FXS voice subscriber line
3/0 to the FXO voice subscriber line.
<Sysname> system-view
[Sysname] subscriber-line 1/0
[Sysname-subscriber-line1/0] hookoff-mode delay bind 3/0
hookoff-time
Use hookoff-time to configure the on-hook timer length.
Use undo hookoff-time to restore the default on-hook timer length.
Syntax
hookoff-time time
undo hookoff-time
Default
No on-hook timer length is set.
Views
Analog FXO voice subscriber line view
Default command level
2: System level
Parameters
time: Length of the on-hook timer in seconds, in the range of 60 to 36000.
Examples
# Set the on-hook timer length to 500 seconds.