R2511-HP MSR Router Series Voice Configuration Guide(V5)

86
Step Command Remarks
3. Create a TS set for digital
E&M signaling and select a
start mode.
timeslot-set ts-set-number
timeslot-list timeslots-list signal
{ e&m-delay | e&m-immediate |
e&m-wink }
N/A
4. Exit E1/T1 interface view.
quit N/A
5. Enter digital E&M voice
subscriber line view.
subscriber-line
slot-number:ts-set-number
N/A
6. Configure the maximum
interval between any two
digits of a dialed number.
timer dial-interval seconds
Optional.
The default is 10 seconds.
7. Configure the maximum time
the calling party waits for a
ringback response.
timer ring-back seconds
Optional.
The default is 60 seconds.
8. Configure the maximum time
the called party waits for the
first digit.
timer wait-digit { seconds |
infinity }
Optional.
The default is 5 seconds.
Querying the circuits of a timeslot or a range of timeslots
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter E1/T1 interface view.
controller { e1 | t1 } slot-number N/A
3. Create a TS set for digital
E&M signaling and select a
start mode.
timeslot-set ts-set-number timeslot-list
timeslots-list signal { e&m-delay |
e&m-immediate | e&m-wink }
N/A
4. Enter digital E&M signaling
view.
cas ts-set-number N/A
5. Query the circuits of a timeslot
or a range of timeslots.
ts query timeslots timeslots-list Optional.
Configuring digital LGS signaling
Configuration the time adjustment function
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter E1/T1 interface view.
controller { e1 | t1 } slot-number N/A
3. Create a TS set, enable digital
LGS signaling and set its start
mode.
timeslot-set ts-set-number
timeslot-list timeslots-list signal
{ fxo-ground | fxs-ground |
fxo-loop | fxs-ground | fxs-loop }
Optional.
4. Quit digital LGS signaling
view.
quit N/A