R2511-HP MSR Router Series Voice Configuration Guide(V5)

87
Step Command Remarks
5. Enter voice subscriber line
view.
subscriber-line:
ts-set-number:ts-set-number
N/A
6. Configure the dial delay.
delay start-dial value
Optional.
1 second by default.
7. Configure the maximum time
waiting for the subscriber to
dial the first digit.
timer first-dial seconds
Optional.
10 seconds by default.
8. Configure the maximum
interval between any two
dialed digits.
timer dial-interval seconds
Optional.
10 seconds by default.
9. Configure the maximum time
that the calling party waits for
a ringback response.
timer ring-back seconds
Optional.
60 seconds by default.
Querying the circuits of a timeslot or a range of timeslots
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter E1/T1 interface view.
controller { e1 | t1 } slot-number N/A
3. Create a TS set for digital LGS
signaling and select a start
mode.
timeslot-set ts-set-number timeslot-list
timeslots-list signal { fxo-ground | fxo-loop |
fxs-ground | fxs-loop }
N/A
4. Enter digital signaling view.
cas ts-set-number N/A
5. Query the circuits of a timeslot
or a range of timeslots.
ts query timeslots timeslots-list Optional.
Configuring a BSV BRI interface
BSV interface
The BRI S/T voice (BSV) interface supports transmission of voice and data, can receive, send, compress,
de-compress digital PCM voice traffic on ISDN BRI interfaces, and realizes VoIP function through other
WAN interfaces of the router.
Generally, a BSV interface is used to connect an ISDN digital telephone, and also can be used as a trunk
interface connecting to a PBX digital trunk. If it cooperates with an FXS or FXO interface, a BSV interface
can realize flexible route selection policies for voice calls.
Configuration prerequisites
The router is equipped with an applicable BSV interface card.
Configuration procedure
To configure a BSV BRI interface: