R2511-HP MSR Router Series Voice Configuration Guide(V5)

[RouterB-voice-dial] entity 2002 pots

# Configure a target match-template for the POTS voice entity.

[RouterB-voice-dial-entity2002] match-template 07552002

# Associate the POTS voice entity with subscriber line 1/1:1.

[RouterB-voice-dial-entity2002] line 1/1:1

[RouterB-voice-dial-entity2002] send-number all

[RouterB-voice-dial-entity2002] quit

# Create a VoIP voice entity.

[RouterB-voice-dial] entity 010 voip

# Configure a target match-template for the VoIP voice entity.

[RouterB-voice-dial-entity10] match-template 010....

# Configure the target address of the VoIP voice entity.

[RouterB-voice-dial-entity10] address ip 1.1.1.1

E1 voice DSS1 signaling configuration example

Network requirements

As shown in Figure 24, Telephones in City A and City B communicate with each other through voice

routers (Router A and Router B) across an IP network.

• In City A, Router is connected to a PBX through an E1 subscriber line, and to the telephone at

0101003 through an FXS voice subscriber line.

• In City B, Router B is connected only to a PBX through an E1 subscriber line.

The two routers communicate with their respective PBX by exchanging DSS1 user signaling through an

ISDN interface. One-stage dialing mode is configured on the two routers.

Figure 24 Network diagram

Configuration procedure

1. Configure Router A:

# Configure the IP address 1.1.1.1/24 for the interface Ethernet 2/1.

<RouterA> system-view

[RouterA] interface ethernet 2/1

[RouterA-Ethernet2/1] ip address 1.1.1.1 255.255.255.0

[RouterA-Ethernet2/1] quit

# Create an ISDN PRI group on interface E1 1/1.

[RouterA] system-view