R2511-HP MSR Router Series Voice Configuration Guide(V5)

101
Table 12 Metacharacters
Metacharacter Meanin
g
0-9 Digits 0 through 9.
Pound sign (#) and
asterisk (*)
Each indicates a valid digit.
Dot (.)
Wildcard, which can match any valid digit. For example, 555…. can match any
number beginning with 555 and ending in four additional characters.
Hyphen (-)
Used to connect two numbers (The smaller comes before the larger) to indicate a range
of numbers, for example, 1-9 inclusive.
Brackets ([ ])
Delimits a range for matching. It can be used together with signs such as !, %, and +.
For example, [235-9] indicates one number of 2, 3, and 5 through 9.
Parentheses (( ))
Indicates a sub-expression. For example, (086) indicates the character string 086. It is
usually used together with signs such as !, %, and +. For example, (086)!010 can
match two character strings 010 and 086010.
Exclamation point (!)
A control character, indicating that the sub-expression before it appears once or does
not appear. For example, (010)!12345678 can match 12345678 and
01012345678.
Plus sign (+)
A control character, indicating that the sub-expression before it appears one or more
times. However, if a calling number starts with the plus sign, the sign itself does not
have special meanings and only indicates that the following is an effective number and
the whole number is E.164-compliant. For example, 9876(54)+ can match 987654,
98765454, 9876545454, and so on, and +110022 is an E.164-compliant number.
Percent sign (%)
A control character, indicating that the sub-expression before it appears multiple times
or does not appear. For example, 9876(54)% can match 9876, 987654,
98765454, 9876545454, and so on.
The sub-expression (one digit or digit string) before a control character such as exclamation point (!), plus
sign (+), and percent sign (%) can appear for the corresponding times indicated by the control character.
For example, (100)+ can match 100, 100100, 100100100, and so on. Once any number of them is
matched, the match is considered an exact match. In the longest match mode, the voice gateway will
ignore subsequent digits dialed by the subscriber after an exact match. (For the case that the gateway
needs to wait for subscribers to continue dialing after an exact match, see the description for T mode.)
The characters (\) and (|) are mainly used in regular expressions and cannot be used as common
characters. The character (\) is an escape character. If you want a control character to represent itself,
you need to add the escape character (\) before it. For example, (\+) represents the character (+) itself
because (+) is a control character in regular expressions. The character (|) means that the current
character (string) is the character (string) on either the left or the right. For example, 0860108888|T
means that the current character string is either 0860108888 or T.
T mode—The character T in the match-template match-string means that the voice gateway should wait
for more digits until the number exceeds the maximum length or the dial timer expires.
If a number starts with the plus sign (+), note the following when you use it on a trunk: the E&M, R2, and
LGS signaling uses DTMF, and as the plus sign (+) does not have a corresponding audio, the number
cannot be transmitted to the called side successfully. While the DSS1 signaling uses ISDN transmission,
the above problem does not exist. Therefore, you should avoid using a number that cannot be identified
by the signaling itself; otherwise, the call will fail.