R2511-HP MSR Router Series Voice Configuration Guide(V5)

105
• If the router is configured to use longest match mode, it will wait for further digits. After the dial timer
expires, the router will ignore the configured longest match mode and automatically use shortest
match to establish a call connection.
When a subscriber dials 0106688#, if you configure the router to use longest match mode and
the dial terminator "#" on the router, the router will as well ignore the configured longest match
mode and use shortest match mode to establish a call connection.
To configure a global number match mode:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter voice dial program
view.
dial-program N/A
4. Configure a global number
match mode.
number-match { longest |
shortest }
By default, the shortest match mode
is adopted.
Configuring a dial terminator
In areas where variable-length numbers are used, you can specify a character as the dial terminator so
that the voice gateway can dial out the number before the dialing interval expires. The dial terminator
identifies the end of a dialing process, and a call connection will be established based on the received
digits when the dial terminator is received. The voice gateway will not wait for further digits even if the
longest match mode has been globally configured.
To configure a dial terminator:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter voice dial program
view.
dial-program N/A
4. Configure a dial terminator.
terminator character
Optional.
By default, no dial terminator is
configured.
If you set the argument character to
# or *, and if the first character of
the configured entity number is the
same as the argument character (#
or *), the device will take this first
character as a common number
rather than a dial terminator.
Number match mode configuration example
Figure 28 and the following describe the configurations for different number match modes on Router A
and Router B: