R2511-HP MSR Router Series Voice Configuration Guide(V5)

118
Step Command Remarks
9. Exit voice dial program view
and enter voice view.
quit N/A
10. Exit voice view and enter
system view.
quit N/A
11. Enter voice subscriber line
view.
subscriber-line line-number N/A
12. Configure a number
substitution rule list for a
subscriber line.
substitute { called | calling }
list-number
Optional.
By default, no number substitution
rule list is configured for a
subscriber line.
IMPORTANT:
W
hatever number substitution mode is confi
g
ured, the voice
g
ateway performs number substitution only
once on a given number.
Configuring a number sending mode
Configure a number sending mode to control how the originating gateway sends a called number. Three
number sending modes are available:
• Send the least significant digits (configured by the send-number digit-number command) of a
called number.
• Sends all digits of a called number.
• Send a truncated called number. When the match-template command configured for a voice entity
contains an ending wildcard, only the digits that match the wildcard are sent.
Configuration prerequisites
The required basic configurations have been completed on POTS entities.
Configuration procedure
To configure a number sending mode:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter voice dial program
view.
dial-program N/A
4. Enter POTS voice entity view.
entity entity-number pots N/A
5. Configure a number sending
mode.
send-number { digit-number | all |
truncate }
By default, the truncate mode is
used.
6. Bind a number template to the
local voice entity.
match-template match-string
By default, no number template is
bound to the local or trunk voice
subscriber line.