R2511-HP MSR Router Series Voice Configuration Guide(V5)
140
Authentication information selection rule
If the authentication information is configured with the user command, POTS entity view is preferred.
Otherwise, the authentication information configured in SIP client view is used.
If realm is configured on a SIP UA, make sure the value is the same as that configured on the server.
Otherwise, the SIP UA will fail the authentication due to mismatch. If realm is not configured on the SIP
UA, the SIP UA will perform no realm match and consider that the value of realm configured on the server
is trusted.
If it is necessary to configure authentication information in POTS entity view or IVR entity view, the same
authentication information is recommended for the POTS entities or IVR entities configured with the same
telephone number.
IMPORTANT:
In the case of authentication, it is forbidden to execute the user command after the re
g
istration function is
enabled because this operation might result in a registration update failure.
The configuration on the SIP server is completed.
Configuration procedure
To configure global SIP authentication information:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter SIP client view.
sip N/A
4. Configure global SIP
authentication
information.
user username password { cipher |
simple } password [ cnonce cnonce
| realm realm ] *
Optional.
By default, the SIP username is
VOICE-GATEWAY and the
authentication password is VOICE-SIP in
SIP client view.
To configuring SIP authentication information in POTS or IVR entity view:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter voice dial program
view.
dial-program N/A
4. Enter voice entity view.
entity entity-number { ivr | pots } N/A
5. Configure SIP authentication
information in POTS entity
view or IVR entity view.
user username password { cipher |
simple } password [ cnonce cnonce
| realm realm ] *
Optional.
By default, no SIP authentication
information is configured in POTS
entity view or IVR entity view.