R2511-HP MSR Router Series Voice Configuration Guide(V5)
180
Ste
p
Command
Remarks
5. Configure the IP
address of the local
SIP server as the IP
address of a local
interface.
server-bind ipv4 ipv4-address
[ port port-number ] [ expires
time-interval ]
By default, no IP address is configured,
that is, there is no local SIP server.
Note that the ipv4-address argument can
be the IP address of an interface on the
local router, or a loopback address such
as 127.0.0.1. Because the local SIP
server cannot accept registrations from
users when the server IP address is set to
127.0.0.1, the IP address of an interface
on the local router is recommended.
You can configure this command only
when the local SIP server is disabled.
6. Enable the local SIP
server.
server enable
By default, the local SIP server is disabled.
The functions of the local SIP server can
take effect after you execute this
command.
To configure the alive mode:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter SIP server view.
sip-server N/A
4. Configure the local SIP
server to operate in the
alive mode.
mode alive-server
By default, the local SIP server operates in
the alone mode.
Note that you can change the operation
mode of the local SIP server only when the
local SIP server is disabled.
5. Set the local SIP server
address to the IP
address of an interface
on the local router.
server-bind ipv4 ipv4-address
[ port port-number ] [ expires
time-interval ]
By default, no IP address is bound, that is,
there is no local SIP server.
Note that the ipv4-address argument can
be the IP address of an interface on the
local router, or a loopback address such
as 127.0.0.1. Because the local SIP
server cannot accept registrations from
users when the server IP address is set to
127.0.0.1, the IP address of an interface
on the local router is recommended.
You can configure this command only
when the local SIP server is disabled.
6. Configure the
keepalive probe.
probe remote-server ipv4
ipv4-address [ port port-number ]
[ keepalive time-interval ]
Optional.
By default, the keepalive probe is not
configured.
This command is valid only when the local
SIP server operates in the alive mode, and
can be configured only when the local SIP
server is disabled.