R2511-HP MSR Router Series Voice Configuration Guide(V5)

245
To configure three-party conference in active participation mode on a telephone:
Enable ke
y
s Disable ke
y
s
*34# #34#
Configuring three-party conference in active participation
mode by using command lines
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice subscriber line
view.
subscriber-line line-number N/A
3. Enable three-party conference
in active participation mode.
joined-conference enable Disabled by default.
For the detailed configuration example, see "Silent monitor and barge in."
Configuring calling party control
This section describes the procedure for enabling and configuring calling party control.
Configuration prerequisites
The router is equipped with an FXS voice interface card.
Configuring calling party control
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice subscriber line
view.
subscriber-line line-number N/A
3. Enable calling party control
and set the on-hook delay
time of the called party.
timer called-hookon-delay
seconds
Calling party control is disabled by
default, that is, the on-hook delay
of the called party is set to 0.
Configuring Feature service
For the convenience of operation, VCX devices provide various features. Some of these features are
directly implemented through Feature messages and others are implemented through SIP messages. All
these features are implemented through exchange of special codes with VCX devices. They are called
Feature service.
After the system administrator enables the setting of the Feature service by using command lines, you can
dial some special codes on telephone terminals to implement these features. The setting of the Feature
service starts with an asterisk (*). After the setting is completed, you will hear the system playing tones
indicating whether the setting succeeds or fails.