R2511-HP MSR Router Series Voice Configuration Guide(V5)
292
Ste
p
Command
Remarks
4. Create an IVR voice entity node
and enter node view.
node node-id { call | jump |
service }
N/A
5. Configure description string for
the node.
description string
Optional.
By default, no description is
configured for an IVR voice entity
node.
Configuring a Call node
Use Call nodes to configure the secondary call function. You can configure two kinds of dial plans for a
Call node: normal secondary call and extension secondary call. If you configure both dial plans for a
Call node, the extension secondary call plan takes precedence over the normal secondary call plan, that
is, after the subscriber dials the secondary call number, the system matches it with the extension
secondary call numbers first, and then matches it with the normal secondary call numbers.
To handle input errors and input timeouts, configure error processing and timeout processing methods for
a node. If you do not configure the methods, global processing methods apply.
A timeout under a Call node is different from that under a Jump node. A timeout under a Call node can
be either a timeout before the first dial or after the first dial. If the timeout happens before the first dial,
the system applies the timeout processing method. If the timeout happens after the first dial, the system
applies the input error processing method. Therefore, the timeout processing method configured for a
node is used to handle the timeout before the first dial. After the first dial, the timeout time for the next dial
is 10 seconds by default.
To configure a Call node:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter IVR management view.
ivr-system N/A
4. Enter Call node view.
node node-id call N/A
5. Configure a dial plan for the
call node.
• Configure an extension
secondary call for the node
extension extension-number
call corresponding-number
• Configure the normal
secondary call number match
mode for the node
call-normal { length
number-length | matching |
terminator character }
Use either method.
6. Configure a dial prefix for the
call node.
dial-prefix string
Optional.
By default, no dial prefix is
configured.