R2511-HP MSR Router Series Voice Configuration Guide(V5)

19
Step Command Remarks
4. Enter VoIP voice entity view.
entity entity-number voip N/A
5. Enable fast connection.
fast-connect Disabled by default.
6. Enable the tunneling.
tunnel-on
Disabled by default.
This command is applicable only
after the fast connection is
enabled.
7. Configure the out-of-band
DTMF transmission.
outband { h225 | h245 }
Optional.
Inband transmission by default.
Enabling VAD
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter voice dial program view.
dial-program N/A
4. Create a VoIP voice entity and
enter VoIP voice entity view.
entity entity-number voip N/A
5. Enable VAD.
vad-on
Optional.
Disabled by default.
Note that the G.711 codec does
not support VAD.
Configuring options related to dial plan
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter voice dial program view.
dial-program N/A
4. Create a VoIP voice entity and
enter VoIP voice entity view.
entity entity-number voip N/A
5. Configure calling numbers
permitted to originate calls to
the local voice entity.
caller-permit calling-string
Optional.
By default, no calling number is
configured, that is, incoming calls
are not restricted.
6. Configure the priority of the
VoIP voice entity.
priority priority-order
Optional.
By default, the priority level is 0.
The smaller the number, the higher
the priority.
For more information about the above commands, see "Configuring dial plans."