R2511-HP MSR Router Series Voice Configuration Guide(V5)

319
Configuring VoFR packets to carry a timestamp
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter voice dial program
view.
dial-program N/A
4. Enter VoFR entity view.
entity entity-number vofr N/A
5. Configure a match template
for the VoFR entity.
match-template match-string
By default, no match template is
configured for the VoFR entity.
6. Configure VoFR packets to
carry a timestamp.
timestamp
Optional.
By default, voice packets do not
carry any timestamp.
Note that only the call control
protocol in the Huawei-compatible
mode supports the timestamp
function.
Configuring nonstandard-compatible mode
Configuration prerequisites
Before configuring nonstandard compatible VoFR, complete the following tasks:
• Configure POTS entities.
• Configure VoFR entities.
Configuring a call mode
For details, see "Configuring a call mode."
Configuring a call control protocol
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter serial interface view.
interface serial interface-number N/A
3. Specify the link layer protocol
for interface encapsulation as
frame relay.
link-protocol fr [ ietf |
nonstandard ]
By default, the link layer protocol
for interface encapsulation is PPP.
4. Enter interface DLCI view.
fr dlci dlci-number N/A
5. Specify the VoFR call control
protocol on DLCI as
nonstandard-compatible.
vofr nonstandard-compatible
signal-channel ccid-no
data-channel dcid-no [ keepalive ]
By default, no VoFR call control
protocol is supported.
Configuring CID selection mode
For details, see "Configuring a CID selection mode."