R2511-HP MSR Router Series Voice Configuration Guide(V5)

324
[RouterB-voice-dial-entity10] match-template 0101001
[RouterB-voice-dial-entity10] address vofr-dynamic serial 1/0 100
[RouterB-voice-dial-entity10] quit
# Configure the local POTS entity (07552001).
[RouterB-voice-dial] entity 2001 pots
[RouterB-voice-dial-entity2001] match-template 07552001
[RouterB-voice-dial-entity2001] line 2/0
Nonstandard-compatible VoFR
Network requirements
As shown in Figure 102, Telephone A (010-1001) attached to voice Router A in City A communicates with
Telephone B (0755-2001), which is attached to voice Router B in City B over a frame relay network.
Router B is an industry-leading router. Router A is an HP router.
Router A adopts the nonstandard-compatible call control protocol.
Figure 102 Network diagram
Configuration procedure
1. Configure Router A:
# Create a new frame relay class VoFR and set the maximum amount of voice bandwidth.
<RouterA> system-view
[RouterA] fr class vofr
[RouterA-fr-class-vofr] voice bandwidth 32000 reserved
# Configure the fragment size of data packets in the case that the voice function is disabled.
[RouterA-fr-class-vofr] fragment 100 data-level
# Configure the fragment size of data packets in the case that the voice function is enabled.
[RouterA-fr-class-vofr] fragment 20 voice-level
[RouterA-fr-class-vofr] quit
# Enter interface Serial 2/0 view and configure the encapsulation format.
[RouterA] interface serial 2/0
[RouterA-Serial2/0] link-protocol fr ietf
# Enter DLCI 100 view and set the frame relay class to VoFR for DLCI.
[RouterA-Serial2/0] fr dlci 100
[RouterA-fr-dlci-Serial2/0-100] fr-class vofr
# Specify the call control protocol to be used by DLCI 100 as nonstandard-compatible.
[RouterA-fr-dlci-Serial2/0-100] vofr nonstandard-compatible signal-channel 5
data-channel 4 keepalive
[RouterA-fr-dlci-Serial2/0-100] quit
[RouterA-Serial2/0] quit
# Configure the VoFR entity (07552001).
[RouterA] voice-setup