R2511-HP MSR Router Series Voice Configuration Guide(V5)

336
authorization, and accounting functions on the voice gateway. This rule applies to one-stage
dialing users and two-stage dialing users.
• Calls will be released in the case of an accounting failure.
Configuration prerequisites
A voice interface card (for example, an FXS interface card) is inserted in the router.
Configuration procedure
To enable the accounting function for one-stage dialing users:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter voice AAA client view.
aaa-client N/A
4. Enable the accounting function
for one-stage dialing users.
accounting-did Disabled by default.
Enabling authentication function for one-stage dialing users
For one-stage dialing users, there is no access number. It is impossible to enable the authentication
function for an individual user according to the identification. Therefore, the authentication function can
only be enabled for all one-stage dialing users.
Before enabling the authentication function, make sure that the RADIUS server and RADIUS client (voice
gateway) can communicate with each other at the network layer and that a list of one-stage dialing users
as well as authentication policies has been configured on the RADIUS server.
Configuration prerequisites
A voice interface card (for example, an FXS interface card) is inserted in the router.
Configuration procedure
To enable the authentication function for one-stage dialing users:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter voice AAA client view.
aaa-client N/A
4. Enable the authentication function for
one-stage dialing users.
authentication-did Disabled by default.
Enabling authorization function for one-stage dialing users
Similar to the authentication function, it is impossible to enable the authorization function for an
individual one-stage dialing user according to the identification because there is no access number.
Therefore, the authorization function can only be enabled, if necessary, for all one-stage dialing users.
Before enabling the authorization function, you must make sure that the authentication function is
enabled on the RADIUS client, that the RADIUS server and RADIUS client can communicate with each