R2511-HP MSR Router Series Voice Configuration Guide(V5)

341
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter dial program view.
dial-program N/A
4. Enter access number view.
gw-access-number access-number
N/A
5. Enable the authorization
function for two-stage dialing
users.
authorization Disabled by default.
Configuring the method of collecting the digits of called
number
Use the callednumber receive-method command to configure the device to originate a call immediately
after all digits of a called number are collected or after a dial terminator # is collected.
The configuration applies to the card number/password process, caller number process, and caller
number process with IVR.
Configuration prerequisites
You have configured an access number.
Configuration procedure
To configure the method of collecting digits of a called number:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter dial program view.
dial-program N/A
4. Enter access number view.
gw-access-number access-number
N/A
5. Configure the method of
collecting digits of a called
number.
callednumber receive-method
{ immediate | terminator }
By default, users need to press the
dial terminator # after dialing all
digits of a called number.
NOTE:
If a user first presses the dial terminator #, the device will i
g
nore it and will not consider it as an error, and
the user can continue to dial a number. This rule applies to both card numbers and passwords.
Configuring the timeout interval between two digits for
two-stage dialing users
Configuration prerequisites
You have configured an access number.