R2511-HP MSR Router Series Voice Configuration Guide(V5)

342
Configuration procedure
To configure the timeout interval for a user to dial the next digit in a two-stage dialing process:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter dial program view.
dial-program N/A
4. Enter access number view.
gw-access-number access-number N/A
5. Configure the timeout interval for
a user to dial the next digit in a
two-stage dialing process.
timer two-stage dial-interval seconds
The default is 10
seconds.
Configuring the number of digits in a card number/password
For the card number/password process, it is necessary to stipulate the number of digits in a card
number/password. This facilitates user management and access control.
Configuration prerequisites
You have configured an access number.
Configuration procedure
To configure the number of digits in a card number and that in a password:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter dial program view.
dial-program N/A
4. Enter access number view.
gw-access-number access-number N/A
5. Specify the two-stage dialing
process as the card
number/password process.
process-config cardnumber
N/A
6. Configure the number of digits in
a card number.
card-digit card-digit
The default is 12.
This command applies only to
the card number process. It is
unavailable in the case of the
caller number process and
caller number process with IVR.
7. Configure the number of digits in
a password.
password-digit password-digit
The default is 6.
This command applies only to
the password process. It is
unavailable in the case of the
caller number process and
caller number process with IVR.