R2511-HP MSR Router Series Voice Configuration Guide(V5)

35
Customizing call progress tones for a country
You can customize the call progress tones of a country if necessary.
To customize call progress tones for a country:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Customize call
progress tone
parameters.
vi-card cptone-custom { busy-tone |
congestion-tone | dial-tone |
ringback-tone | special-dial-tone |
waiting-tone } comb freq1 freq2 time1
time2 time3 time4
By default, no call progress tones
are customized.
4. Select a country.
cptone country-type CS
By default, the country mode is
China.
5. Configure the level
parameter for the
customized call
progress tones.
cptone tone-type { all | busy-tone |
congestion-tone | dial-tone |
ringback-tone | special-dial-tone |
waiting-tone } amplitude value
Optional.
By default, 1000 for busy tone and
congestion tone, 400 for dial tone
and special dial tone, and 600 for
ringback tone and waiting tone.
Configuring basic functions
This section covers prerequisites and procedures for configuring basic functions.
Configuration prerequisites
The router is equipped with an applicable FXS, FXO, E&M, or BSV voice interface card.
NOTE:
The commands in FXS, FXO, E&M, or BSV voice subscriber line view are applicable only when the router
is equipped with an FXS, FXO, or E&M interface card.
Configuration procedure
This section describes the basic functions of voice subscriber lines generated by voice cards.
Configurations specific to a voice subscriber line will be introduced individually.
To complete the basic functions of voice subscriber lines:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice subscriber line
view.
subscriber-line line-number N/A