R2511-HP MSR Router Series Voice Configuration Guide(V5)

45
Configuring signal type
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice subscriber line
view.
subscriber-line line-number N/A
3. Configure a signal type for the
E&M voice subscriber line.
type { 1 | 2 | 3 | 5 }
The default is 5 (corresponding V
type signal).
Configuring start mode
To configure the immediate start mode:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice subscriber line
view.
subscriber-line line-number N/A
3. Configure the immediate start
mode for the E&M voice
subscriber line.
em-signal immediate
The default is immediate start mode
by default.
4. Configure a delay before the
originating side sends DTMF
signals in the immediate start
mode.
delay send-dtmf milliseconds
Optional.
The default is 300 milliseconds.
To configure the delay start mode:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice subscriber line view.
subscriber-line line-number N/A
3. Configure the delay start mode for the
E&M voice subscriber line.
em-signal delay N/A
4. Configure the delay signal duration in
the delay start mode.
delay hold milliseconds
Optional.
The default is 400 milliseconds.
5. Configure the delay time from when the
terminating side detects a seizure
signal to when it sends a delay signal
in the delay start mode.
delay rising milliseconds
Optional.
The default is 300 milliseconds.
To configure the wink start mode:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice subscriber line view.
subscriber-line line-number N/A