R2511-HP MSR Router Series Voice Configuration Guide(V5)

65
Step Command Remarks
5. Configure an E1 trunk routing
mode.
select-mode { max | maxpoll | min
| minpoll }
Optional.
By default, the timeslot with the
lowest number is selected from all
available timeslots for routing.
Set the physical state change suppression interval on an E1
interface
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter E1 interface view.
controller e1 slot-number N/A
3. Set the physical state change
suppression interval on the E1
interface.
link-delay delay-time
Optional.
By default, the physical state
change suppression is disabled on
an E1 interface.
Restoring default settings for an E1 voice interface
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter E1 interface view.
controller e1 slot-number N/A
3. Restore the default settings on
the E1 voice interface.
default Optional.
Configuring basic parameters for a T1 voice
interface
This section describes the basic parameters and procedures for configuring a T1 voice interface.
Configuring a TDM clock source
The TDM clock source configuration for a T1 interface is similar to that for an E1 interface. For more
information, see "Introduction to TDM clock source."
To configure a TDM clock source:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter T1 interface view.
controller t1 slot-number N/A