R2511-HP MSR Router Series Voice Configuration Guide(V5)

77
Configuring basic R2 signaling parameters
Configuring the country or region mode
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter E1/T1 interface view.
controller { e1 | t1 } slot-number N/A
3. Create a TS set and enable R2
signaling for it.
timeslot-set ts-set-number
timeslot-list timeslots-list signal r2
N/A
4. Enter R2 CAS view.
cas ts-set-number N/A
5. Configure the country or
region mode.
mode zone-name
[ default-standard ]
Optional.
By default, the ITU-T mode is
adopted.
Configuring the trunk direction for R2 signaling
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter E1/T1 interface view.
controller { e1 | t1 } slot-number N/A
3. Create a TS set and enable R2
signaling for it.
timeslot-set ts-set-number
timeslot-list timeslots-list signal r2
N/A
4. Enter R2 CAS view.
cas ts-set-number N/A
5. Configure the trunk direction
for R2 signaling.
trunk-direction timeslots
timeslots-list { dual | in | out }
Optional.
Bidirectional by default.
Enabling the terminating side to send busy tones to the calling subscriber
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter E1/T1 interface view.
controller { e1 | t1 } slot-number N/A
3. Create a TS set and enable R2
signaling for it.
timeslot-set ts-set-number
timeslot-list timeslots-list signal r2
N/A
4. Enter R2 CAS view.
cas ts-set-number N/A
5. Enable the terminating side to
send busy tones to the calling
subscriber.
sendring ringbusy enable
Optional.
By default, the terminating side
sends busy tones to the calling
subscriber.
6. Configure the duration of
playing busy tones.
timer ring { ringback | ringbusy }
time
Optional.
By default, the duration of playing
busy tones is 30,000 milliseconds.