R2511-HP MSR Router Series Voice Configuration Guide(V5)

80
Step Command Remarks
13. Set timeout values of line
signals.
timer dl { answer | clear-back |
clear-forward | | re-answer |
release-guard | seize } time
Optional.
The default is 60,000 milliseconds
for answer signal; 10,000
milliseconds for clear-back signal
and clear-forward signal and
release-guard signal; 1,000
milliseconds for seizure signal and
re-answer signal.
Table 11 Default values of signals in R2 digital line signaling
Signal Default rx-bits ABCD Default tx-bits ABCD
Answer 0101 0101
Blocking 1101 1101
Clear-back 1101 1101
Clear-forward 1001 1001
Idle 1001 1001
Seize 0001 0001
Seizure-ack 1101 1101
Release-guard 1001 1001
Configuring R2 interregister signaling
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter E1/T1 interface view.
controller { e1 | t1 } slot-number N/A
3. Create a TS set and enable R2
signaling for it.
timeslot-set ts-set-number
timeslot-list timeslots-list signal r2
N/A
4. Enter R2 CAS view.
cas ts-set-number N/A
5. Enable the terminating side to
request calling party
information.
ani { all | ka }
Optional.
Disabled by default.
6. Configure the number of
digits that should be collected
to request a calling party flag.
ani-offset number
Optional.
The default for the number
argument is 1.
7. Adopt Group B signals to
complete interregister
signaling exchange.
group-b enable
Optional.
Group B signals are used by
default.
8. Enable this end to send a
number terminator to the
terminating side.
final-callednum enable
Optional.
Disabled by default.