R2511-HP MSR Router Series WLAN Command Reference(V5)

53
WLAN RRM configuration commands
NOTE:
The terms
AP and fat AP in this document refer to MSR900, MSR93X(JG512A, JG519A and JG597A),
and MSR20-1X routers with IEEE 802.11b/
g
and MSR series routers installed with a SIC WLAN module.
autochannel-set avoid-dot11h
Use autochannel-set avoid-dot11h to configure that only the non-dot11h channels of the country code are
scanned during initial channel selection.
Use undo autochannel-set to restore the default.
Syntax
autochannel-set avoid-dot11h
undo autochannel-set
Default
All channels of the country code are scanned.
Views
WLAN RRM view
Default command level
2: System level
Usage guidelines
Some of 802.11h channels, also called radar channels, overlap some 802.11a channels. If the device
operates on an overlapping channel, its service quality might be affected. With this command enabled,
the device selects a working channel from non-802.11h channels belonging to the configured country
code to avoid channel collision.
Examples
# Configure RRM to scan only non-dot11h channels.
<Sysname> system-view
[Sysname] wlan rrm
[Sysname-wlan-rrm] autochannel-set avoid-dot11h
display wlan rrm
Use display wlan rrm to display basic RRM configuration information.
Syntax
display wlan rrm [ | { begin | exclude | include } regular-expression ]
Views
Any view