R2511-HP MSR Router Series WLAN Command Reference(V5)

70
Views
Service template view
Default command level
2: System level
Parameters
rsn: Enables the Robust Security Network (RSN) information element in the beacon and probe response
frames sent by the AP. The RSN IE advertises the RSN capabilities of the AP.
wpa: Enables the Wi-Fi Protected Access (WPA) Information element in the beacon and probe response
frames sent by the AP. The WPA IE advertises the WPA capabilities of the AP.
Examples
# Enable the WPA-IE in the beacon and probe responses.
<Sysname> system-view
[Sysname] wlan service-template 1 crypto
[Sysname-wlan-st-1] security-ie wpa
tkip-cm-time
Use tkip-cm-time to set the TKIP countermeasure time.
Use undo tkip-cm-time to restore the default.
Syntax
tkip-cm-time time
undo tkip-cm-time
Default
The TKIP counter measure time is 0 seconds. No counter measures are taken.
Views
Service template view
Default command level
2: System level
Parameters
time: TKIP counter measure time in seconds. The value is in the range of 0 to 3600 seconds.
Usage guidelines
After TKIP countermeasures are enabled, if more than two MIC failures occur within a certain time, the
TKIP associations are disassociated, and new associations are allowed to establish only after the
specified TKIP counter measure time expires.
Examples
# Set the TKIP counter measure time to 90 seconds.
<Sysname> system-view
[Sysname] wlan service-template 1 crypto
[Sysname-wlan-st-1] tkip-cm-time 90