R2511-HP MSR Router Series WLAN Command Reference(V5)

73
WLAN IDS configuration commands
The terms AP and fat AP in this document refer to MSR900, MSR93X(JG512A, JG519A and JG597A),
and MSR20-1X routers with IEEE 802.11b/g and MSR series routers installed with a SIC WLAN module.
WLAN IDS rogue detection configuration
commands
wlan device-detection enable
Use wlan device-detection enable to configure the AP to operate in hybrid mode.
Use undo wlan device-detection enable to restore the default.
Syntax
wlan device-detection enable
undo wlan device-detection enable
Default
The AP operates in normal mode to provide WLAN services.
Views
System view
Default command level
2: System level
Usage guidelines
If the AP operates in monitor mode, the command is invisible.
Before you change the operating mode of the AP, make sure the radios are disabled. Otherwise, you
cannot change the operating mode.
If the AP operates in hybrid mode, configure a service template so the AP can provide both WLAN
access and rogue detection services.
Examples
# Set the hybrid operation mode for the AP.
<Sysname> system-view
[Sysname] wlan device-detection enable
wlan ids
Use wlan ids to enter WLAN IDS view.
Syntax
wlan ids