R2511-HP MSR Router Series WLAN Configuration Guide(V5)

15
Ste
p
Command Remarks
4. Enable the fat AP to respond
to probe requests with null
SSID.
broadcast-probe reply
Optional.
The default setting is enabled.
Configuring radio parameters
Configuring radio parameters
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter radio interface view.
interface wlan-radio
interface-number
N/A
3. Configure a radio type.
radio-type { dot11b | dot11g
| dot11gn }
Optional.
4. Specify a working channel for the
radio.
channel { channel-number |
auto }
Optional.
By default, auto mode is enabled.
The working channel of a radio
varies with country codes and
radio types. The channel list
depends on your device model.
5. Specify the maximum radio
power.
max-power radio-power
Optional.
By default, the maximum radio
power varies with country codes,
channels, AP models, radio types,
and antenna types. If 802.11n is
adopted, the maximum radio
power also depends on the
bandwidth mode.
6. Specify the type of preamble.
preamble { long | short }
Optional.
By default, the short preamble is
supported.
7. Configure the antenna type.
antenna type type
Optional.
The default setting for the command
depends on the device model.
8. Configure the maximum distance
that the radio can cover.
distance distance
Optional.
By default, the radio can cover 1
km (0.62 miles) at most.
9. Set the interval for sending
beacon frames.
beacon-interval interval
Optional.
By default, the beacon interval is
100 TUs.