R2511-HP MSR Router Series WLAN Configuration Guide(V5)

3
Entering WLAN Ethernet interface view
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter WLAN Ethernet
interface view.
interface wlan-ethernet
interface-number
If the WLAN Ethernet interface
does not exist, this command
creates the WLAN Ethernet
interface first.
3. Specify the expected
bandwidth for the interface.
bandwidth bandwidth-value Optional.
4. Restore the default settings of
the WLAN Ethernet interface.
default Optional.
Configuring a WLAN Ethernet interface
For a WLAN Ethernet interface, you can configure basic settings such as MTU, ARP, DHCP, and routing
protocols as listed in the following table (for information about the commands/features listed in the
following table, see related chapters in the corresponding volumes).
To configure a WLAN Ethernet interface:
Ste
p
Command
5. Configure an interface.
• qos max-bandwidth
• shutdown
• mtu
• description
• enable snmp trap updown
6. Configure ARP.
• arp max-learning-num
• arp proxy enable
• proxy-arp enable
7. Configure the interface as a BOOTP client.
ip address bootp-alloc
8. Configure
DHCP.
Configure DHCP server
dhcp select server global-pool
Configure DHCP relay
• dhcp relay address-check
• dhcp relay information enable
• dhcp relay information format
• dhcp relay information strategy
• dhcp relay release
• dhcp relay server-select
• dhcp select relay
Configure DHCP client ip address dhcp-alloc
9. Configure IP accounting.
• ip count firewall-denied
• ip count inbound-packets
• ip count outbound-packets
10. Assign an IP address to the interface.
ip address