MSR2003 Router FIPS Enclosure Installation Guide

Phillips screwdriver

(User-supplied)

Needle-nose pliers

(User-supplied)

ESD-preventive wrist strap

(User-supplied)

Installation kit

M4 countersunk-head screw

(Supplied with the router)

Mounting brackets

(Supplied with the router)

Opacity shield

M3 countersunk-

head screw

Hex bolt

Installing a FIPS enclosure on a router with front mounting brackets

Face the front panel, install the front mounting brackets on both sides of the router and

secure them with M4 countersunk-head screws, mount the router on a rack shelf (skip this

step if the router is not to be mounted on a rack), and attach the opacity shield.

HP MSR1002-4/1003-8/2003 router meets the requirement of FIPS security level 2.

Tool list

Only use the screws and hex bolts that are supplied in the opacity shield kit to secure

the opacity shield.

Installation preparation

Wear an ESD-preventive wrist strap, and make sure that the wrist strap has a good

skin contact and is well grounded.

The installation procedures must be performed by qualified personnel.

Before installation, read the Compliance and Safety Manual for the compatible

switch of the opacity shield kit.

•

Install hex bolts on the chassis as shown in the figures. (Remove the fastening screws, if any,

from where hex bolts are to be installed.)

Align the holes on the opacity shields

with the hex bolts.

Apply tamper-evidence labels to opacity shields, screws that secure the opacity shields, field

replaceable units (FRUs), USB ports, and air vents on interface cards and filler panels.

Press the opacity shields against the side

panels, and use M3 countersunk-head

screws to secure the opacity shields.

MSR2003

MSR1002-4

PAGE 1
HP MSR1002-4/1003-8/2003 router meets the requirement of FIPS security level 2. Tool list Install hex bolts on the chassis as shown in the figures. (Remove the fastening screws, if any, from where hex bolts are to be installed.) Phillips screwdriver (User-supplied) Needle-nose pliers (User-supplied) ESD-preventive wrist strap (User-supplied) Installation kit Opacity shield Mounting brackets (Supplied with the router) Hex bolt Align the holes on the opacity shields with the hex bolts.
PAGE 2
MSR1002-4 Align the holes on the opacity shields with the hex bolts. Press the opacity shields against the side panels, and use M3 countersunk-head screws to secure the opacity shields. Apply tamper-evidence labels to opacity shields, screws that secure the opacity shields, field replaceable units (FRUs), USB ports, and air vents on interface cards and filler panels.