HP MSR2000 Router Series Installation Guide

26
Connecting an AC power cord
1. Make sure the router is correctly grounded, and the power switch on the router is in the OFF
position.
2. Connect one end of the AC power cord to the AC receptacle on the router, and use a cable tie to
secure the power cord.
3. Connect the other end of the power cord to the AC power source.
Figure 30 Connecting an AC power cord
Verifying the installation
After you complete the installation, verify that:
• There is enough space for heat dissipation around the router, and the rack or workbench is stable.
• Interface modules are correctly installed.
• The router, rack, and power cord are correctly grounded.
• The correct power source is used.
Powering on the router
Verifying before power-on
Before powering on the router, verify the following items:
• The power supplies are correctly installed.
• The power cord and grounding cable are correctly connected.
• The power source voltage meets the requirement of the router.
• The console cable is correctly connected, the terminal or PC used for configuration has started, and
the configuration parameters have been set.