HP MSR2000 Router Series Installation Guide

36
Appendix B LEDs
Panel LEDs
Figure 38 MSR2003 LEDs
(1) Gigabit Ethernet port LED (GE0) (2) Gigabit Ethernet port LED (GE1) (3) Console port LED
(4) USB console port LED (5) System status LED (SYS) (6) Power supply LED (PWR)
LED description
LED State Descri
p
tion
System status LED
(SYS)
Flashing green
(1 Hz)
Comware has started with the configuration file and the router has
booted up.
Flashing green
(8 Hz)
The BootWare runs.
Steady green The SDRAM is performing self-test.
Flashing yellow
(1 Hz)
The DDR3 SDRAM has failed the self-test.
Flashing yellow
(8 Hz)
The extended segment does not exist.
Steady yellow The boot image does not exist.
Off No power input, or exceptions have occurred.
Power supply LED
(PWR1)
Steady green The power supply is operating correctly.
Off No power input.
USB console port LED
Steady on The router is using the USB console port for configuration.
Off The router is not using the USB console port.
CON/AUX port LED
Steady on The router is using the console port for configuration.
Off The router is not using the console port.
Gigabit Ethernet port
LED (GE)
Steady green A 1000 Mbps link is present.
Flashing green Data is being received or transmitted at 1000 Mbps.
Steady yellow A 10/100 Mbps link is present.
Flashing yellow Data is being received or transmitted at 10/100 Mbps.