HP MSR2000/3000/4000 Router Series ACL and QoS Command Reference

68
Related commands
display qos trust interface
Priority trust mode commands
The commands in this section are supported only on routers installed with Layer 2 Ethernet switching
modules. For information about interface modules, see HP MSR Series Routers Interface Module Manual.
display qos trust interface
Use display qos trust interface to display priority trust mode and port priority information on an interface.
Syntax
display qos trust interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number. If no interface is specified,
this command displays priority trust mode and port priority information of all interfaces.
Examples
# Display the priority trust mode and port priority information of Ethernet 1/1.
<Sysname> display qos trust interface ethernet 1/1
Interface: Ethernet1/1
Port priority trust information
Port priority:4
Port priority trust type: dot1p
Table 21 Command output
Field Descri
p
tion
Interface Interface type and interface number.
Port priority Port priority set for the interface.
Port priority trust type
Priority trust mode on the interface:
• dot1p—The 802.1p priority carried in packets is trusted.
• dscp—The DSCP priority carried in packets is trusted.
• none—The port priority is trusted.
qos trust
Use qos trust to configure the priority trust mode for an interface.