HP MSR2000/3000/4000 Router Series Interface Command Reference

102
Examples
# Enable user data inversion on CT1/PRI interface T1 2/0.
<Sysname> system-view
[Sysname] controller t1 2/0
[Sysname-T1 2/0] data-coding inverted
display controller t1
Use display controller t1 to display information about CT1/PRI interfaces.
Syntax
display controller t1 [ interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-number: Specifies a CT1/PRI interface by its number. If you do not specify this argument, the
command displays information about all CT1/PRI interfaces.
Examples
# Display information about interface T1 2/0.
<Sysname> display controller t1 2/0
T1 2/0
Current state: DOWN
Description: T1 2/0 Interface
Basic Configuration:
Work mode: T1 framed, Cable type: 100 Ohm balanced
Frame-format: esf, fdl: none, Line code: b8zs
Source clock: slave, Data-coding: normal
Idle code: ff, Itf type: ff, Itf number: 2
Loop back: not set
Alarm State:
Receiver alarm state is Loss-of-Signal
Transmitter is sending remote alarm
Pulse density violation detected
SendLoopCode History:
Inband-llb-up: 0 times, Inband-llb-down: 0 times
Fdl-ansi-llb-up: 0 times, Fdl-ansi-llb-down: 0 times
Fdl-ansi-plb-up: 0 times, Fdl-ansi-plb-down: 0 times
Fdl-att-plb-up: 0 times, Fdl-att-plb-down: 0 times
BERT state:(stopped, not completed)
Test pattern: 2^15, Status: Not Sync, Sync Detected: 0
Time: 0 minutes, Time past: 0 minutes
Bit Errors (since test started): 0 bits