4000 Router Series Interface Module Guide

167

Connecting a MIM-1SHL-4W interface module cable

• Connect the 4-wire Y type G.SHDSL interface cable as follows:

One end of the cable provides one RJ11 connector, the other end of the cable provides two RJ11

connectors which can be connected to two 2-core telephone cables.

1. Connect the end with only one RJ11 connector of the cable to RJ11 interface on the MIM-1SHL-4W

interface module

2. Connect the other end of the cable to the network device.

• Connect the 4-wire I type G.SHDSL interface cable as follows:

Each end of the cable provides one RJ11 connector which can be connected to one 4-core telephone

cable.

3. Connect one end of the cable to the RJ11 interface on the MIM-1SHL-4W interface module.

4. Connect the other end of the cable to the network device.

Use correct wire pairs when the MIM-1SHL-4W interface module cable is operating in different modes:

• When the interface module cable is operating in dual-wire mode, use Line 0.

• When the interface module cable is operating in four-wire mode, use Line 0 and Line 1.

Table 216 Pinouts of the MIM-1SHL-4W interface module cable

Pin Line Signal

1 1 Tip

2 0 Tip

3 0 Ring

4 1 Ring

WLAN interface

Appearance and applicable models of the WLAN interface module antenna

Table 217 Appearance and applicable models of the WLAN interface module antenna

Cable A

earance A

licable models

WLAN interface

module antenna

SIC-WLAN-b/g/n

SIC-WLAN-b/g/n(NA)