4000 Router Series Interface Module Guide

Attribute Description

Supported wireless band

850/900/1900/2100MHz WCDMA/HSDPA/HSUPA

850/900/1800/1900MHz GPRS/EDGE

Interface LEDs

SIC-3G-HSPA panel is shown in the following figure:

Figure 30 SIC-3G-HSPA panel

The following table describes the LEDs on the SIC-3G-HSPA panel:

Table 49 Description for the LEDs on the SIC-3G-HSPA panel

LED Descri

tion

WWAN

• Steady green means that a link is present.

• Flashing green means that data is being transmitted or received.

RSSI

• Steady green means strong signal.

• Flashing green means middle or low signal.

• OFF means weak signal or no signal.

UMTS

• Steady yellow means the service is valid.

• OFF means no service.

HSDPA

• Steady yellow means the service is valid.

• OFF means no service.

Antenna, interface cables, and the connection methods

CAUTION:

The 3G antenna provided with the SIC-3G-GSM must be installed on the antenna port that has a MAIN

mark.

For more information about SIC-3G-GSM interface cables and the connection methods, see"WLAN

interface."

Installing a SIM card

1. Push the 3G SIM card holder in the direction marked "OPEN" so the holder projects upwards.

Do not insert the 3G SIM card to the card holder before projecting the card holder up or lift the

holder forcibly.

2. Insert the 3G SIM card along the slide rails to the holder.

3. Put down the holder and push the holder in the direction marked "LOCK" to lock the card in

position.

4. Position the 3G SIM card socket cover and fasten the screws on the cover.

5. Execute the display cellular [slot]/0 all command after the router is started. When "SIM Status =

OK" appears in the output information, the SIM card is identified.