HP MSR2000/3000/4000 Router Series IP Multicast Command Reference

100
Views
PIM view
Predefined user roles
network-admin
Parameters
interval: Specifies the interval for sending state refresh messages, in the range of 1 to 255 seconds.
Examples
# Set the interval for sending state refresh messages to 70 seconds on the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-interval 70
Related commands
• pim state-refresh-capable
• state-refresh-rate-limit (PIM view)
• state-refresh-ttl (PIM view)
state-refresh-rate-limit (PIM view)
Use state-refresh-rate-limit to configure the time that the router waits before receiving a new state refresh
message.
Use undo state-refresh-rate-limit to restore the default.
Syntax
state-refresh-rate-limit time
undo state-refresh-rate-limit
Default
The device waits 30 seconds before it receives a new state refresh message.
Views
PIM view
Predefined user roles
network-admin
Parameters
time: Specifies a time that the device waits before receiving a new refresh message, in the range of 1 to
65535 seconds.
Examples
# Configure the device to wait 45 seconds before it receives a new state refresh message on the public
network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-rate-limit 45