4000 Router Series Layer 2 - WAN Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP MSR2003 AC Router

121

122

123

124

125

126

127

128

129

130

115

[RouterA-Dialer0] dialer circular enable

[RouterA-Dialer0] ip address 100.1.1.1 255.255.255.0

[RouterA-Dialer0] dialer-group 1

[RouterA-Dialer0] dialer route ip 100.1.1.2 8810052

[RouterA-Dialer0] dialer route ip 100.1.1.3 8810063

[RouterA-Dialer0] quit

# Set interface Serial 2/0 to operate in asynchronous protocol mode, and assign it to dialer

circular group 0.

[RouterA] interface serial 2/0

[RouterA-Serial2/0] physical-mode async

[RouterA-Serial2/0] async-mode protocol

[RouterA-Serial2/0] dialer circular-group 0

[RouterA-Serial2/0] quit

# Configure interface Serial 2/1 to operate in asynchronous protocol mode, and assign it to dialer

circular group 0.

[RouterA] interface serial 2/1

[RouterA-Serial2/1] physical-mode async

[RouterA-Serial2/1] async-mode protocol

[RouterA-Serial2/1] dialer circular-group 0

[RouterA-Serial2/1] quit

# Enable modem dial-in and dial-out on user interfaces to be used.

[RouterA] user-interface tty1

[RouterA-ui-tty1] modem enable both

[RouterA-ui-tty1] quit

[RouterA] user-interface tty2

[RouterA-ui-tty2] modem enable both

2. Configure Router B:

# Create dialer access group 1 and configure a dial access rule for it.

<RouterB> system-view

[RouterB] dialer-group 1 rule ip permit

# Configure interface Serial 2/0 to operate in asynchronous protocol mode.

[RouterB] interface serial 2/0

[RouterB-Serial2/0] physical-mode async

[RouterB-Serial2/0] async-mode protocol

# Assign an IP address to interface Serial 2/0, associate dialer access group 1 with the interface,

enable C-DDR, and configure two dial strings for calling Router A.

[RouterB-Serial2/0] ip address 100.1.1.2 255.255.255.0

[RouterB-Serial2/0] dialer circular enable

[RouterB-Serial2/0] dialer-group 1

[RouterB-Serial2/0] dialer route ip 100.1.1.1 8810048

[RouterB-Serial2/0] dialer route ip 100.1.1.1 8810049

[RouterB-Serial2/0] quit

# Enable modem dial-in and dial-out on the user interface to be used.

[RouterB] user-interface tty1

[RouterB-ui-tty1] modem enable both

3. Configure Router C: